Gastroback Design Mincer Instruções de Operação descarregar pdf (Página 13)

The mincer blocks up permanently

while operating.

The worm housing moves or loosened while

operating.

The mince leaks out at the side of the

closing ring.

Clear a blocking

If the worm housing is blocked no mince comes out of the mincer while operating or the motor stops

moving automatically because of the overload protection.

ATTENTION: If a blocking occurs tur n OFF the appliance immediately. Clear the problem

before turning on the motor again.

1. Turn the appliance OFF and then take the feedstick out of the feed funnel.

2. If the motor stopped running because the overload protection turned itself on you have to

turn the appliance OFF to undo the overload protection.

3. Press the reverse button and hold it down for one or two seconds. The wor m is moving

backwards and this loosens the blocking.

ATTENTION: If the motor does not star t moving backwards immediately tur n OFF the

appliance and pull the plug. Disassemble and clean the appliance.

• To ensure that the mincer does not seize, never operate it under

excessive pressure. Operate in a slow and constant pace. Do not

try to rush the procedure by pushing down the meat with force.

• For mincing hard ingredients really fine start with the mincer plate

with the bigger holes. Mincing the second time use the finer mincer

plate.

The screw plug loosened. Turn the appliance OFF immediately. Press the

worm housing with one hand against the motor housing using the other

hand to tighten the screw plug turning it clockwise.

The closing ring is not screwed on tight enough. T urn the appliance OFF

immediately and then pull the plug. T ighten the closing ring but do not

overwind the winding. If the problem still occurs disassemble and clean

the appliance.

Possible problem Easy solution

41400_Manual_Fleischwolf_Juli2009.qxp 19.11.2009 09:24 Seite 30

1 2 ... 8 9 10 11 12 13 14 15

Sem comentários

Gastroback Design Mincer Instruções de Operação Página 13